LIGHTS
Interior Halogen
The bulbs inside
the halogen
lighting are
replaceable.
To Replace a Bulb:
1. Rotate the
outer trim ring
counterclockwise and
remove.
2. Carefully grasp bulb and pull from
socket.
3. Use a clean cloth or piece of tissue to
grasp new bulb. DO NOT touch bulb
directly as this can cause a "hot spot"
and result in immediate bulb failure.
4. Align contacts of bulb with terminals in
fi xture base. Insert bulb until contacts
are fi rmly seated.
5. Align tabs in trim ring with slots in
fi xture base. Rotate lens clockwise
until trim ring locks into place.
CAUTION:
DO NOT touch halogen lighting while
on. They can cause a burn. DO NOT
touch replacement bulbs. Oil in the
hands can cause a "hot-spot" to occur. If
the bulb is touched, allow it to cool and
clean the bulb with alcohol.
Map Lights
Operation:
Turn the light on and off by aligning the
pointer on the back of the light with the ON and
OFF indicator on the front portion of the light.
To Replace a Bulb:
1. Align the pointer on the back of the light
to the position to remove the cover.
2. Remove cover and lift bulb from holder.
3. Replace with a 12 Volt DC 4 Watt
060200c
type 1816 bulb and install cover by
realigning the pointer to the same
location. Turn cover to OFF or ON
position.
If Map Lights Fail to Operate:
Ensure interior house power is turned ON.
Check fuses in front electrical bay on the
roadside.
080476b
20 0 8 I M P E R I AL
ELECTRICAL SYSTEMS - HOUSE — 8
BULB USAGE - INTERIOR
INTERIOR BULB CHART
LOCATION
FLUORESCENT
CEILING LIGHTS
DINETTE
ROUND 3" HALOGEN
CEILING LIGHT
ROPE LIGHT
ENTRY HANDLE
LIGHT TUBE
MAP LIGHT
STEPWELL LIGHTS
CLOSET LAMP
080476
BULB NUMBER
F15T8 - CW
12V DC C912
12V DC 10W Type T-3
LITCO 31-120-40
MP# 16615157
1816 12V DC 4W
90416
12V DC 10W Type T-3
189