Tilt & Telescope; Console; Transmission Shift Selector - Holiday Rambler Imperial 2008 Owner's Manual

ELECTRICAL SYSTEMS - CHASSIS — 9
Tilt & Telescope
Tilt and telescope steering wheel control lever
is located on the steering column.
To tilt the steering wheel: Pull the
lever up and tilt the steering wheel to the
desired level. Release the lever to lock
the steering wheel in the new position.
To telescope the steering wheel: Push
and hold the lever down. Move the
steering wheel to the desired location.
Release the lever to lock the steering
wheel in the new position.
Turn indicator and headlight high/low dimmer
control is located on the steering column.
Push the lever forward to activate right
turn indicator circuits when ignition is on.
Pull the lever back to activate left turn
indicator circuits when the ignition is on.
Pull the lever up to select high/low beam
circuits when the headlights are on.
198
Hazard Flashers:
The fl asher button is located on the
steering column.
To turn on the four way fl ashers, pull
out on the fl asher button. The turn signal
alarm will sound.
To turn off the fl ashers, push the button in.

CONSOLE

NOTE:
Switch and component placement on
panels may vary.

Transmission Shift Selector

The keypads on the shift control are R
(Reverse), N (Neutral), D (Drive), Up and
Down arrows, and the Mode button. A digital
display window shows gear selection, various
transmission modes, oil level and transmission
fault codes. Generation 4 keypads have a split
screen displaying two number sets while in
drive. The left number displays the highest
090243 forward range available. The right number is
the range that the transmission is currently in.
NN (Neutral) will appear in the display window
when the ignition is turned On. This indicates
the transmission is in neutral and it is safe
to start. If the NN does not display when the
ignition is turned on, there is no power to the
shift selector and the transmission will not allow
the engine to start. No display is an indicator of
electrical problems with the engine batteries,
ECU or the shift selector.
2 00 8 I MP E R I A L
080355g
Keypad Functions:
Select the Reverse gear by pressing R.
RR will display.
Select Neutral by pressing N. The area
around the N button has a raised ridge so
the driver can orient his hand to the push
buttons by touch without looking at the
display. NN will display.
Select Drive range by pressing D. The
highest forward gear (6th gear) appears
in the display and the transmission will
shift to fi rst gear indicated as 6 1.
The Up and Down arrow buttons are
used to select a higher (if not in "6")
or lower (if not in "1") forward range.
These buttons are not functional in
Neutral or Reverse. When in Drive, one
press changes the gear range selected
by one. If the button is continuously
held, the selected range will change up
or down until the button is released or
until the highest/lowest possible range of
gears is selected.