B.7.2
Installing a New Disk Drive
To install a disk drive in an array, perform the following steps.
1. Gently slide the drive module into the drive slot until the handle pins slip into
the chassis notch.
2. Lower the disk drive handle until it is vertical.
3. Press and hold the drive handle in while you press the thumbscrew in until it
engages the threads.
4. Turn the thumbscrew clockwise until it is finger-tight.
Note – To ensure that a thumbscrew is finger-tight, tighten it with a screwdriver
and then loosen the thumbscrew counterclockwise a quarter-turn.
5. Push the plastic front bezel onto the front of the unit until it is seated firmly, and
use the key to lock the locks.
6. Perform any operations your host software requires to recognize the new drive
and bring it under software control.
B.7.3
Installing an Air Management Sled
The front of an air management sled looks similar to a disk drive module, but the air
management sled is an empty box used to maintain optimum airflow in a chassis.
If you have removed a disk drive and do not intend to replace it, insert an air
management sled to maintain the optimum airflow inside the chassis. You can install
the air management sled by using the same procedure as
Drive" on page
B-11, except that no software operations are necessary.
"Installing a New Disk
Appendix B Cabling JBODs
B-11