Inputting The House Code; Resetting To Factory Default - Response SA1 E Installation And Operating Instructions Manual

5. There are two jumper links located above the
battery compartment.
J2 jumper link: Reset to Factory default
J3 jumper link: System type selection
Anti-Tamper
Switch
System Type
Jumper
Link J3
Jumper link J3 must be set as shown.
1 J 3
6. Connect the 9V PP3
battery clip.
7. Replace the rear cover and refit fixing screws.
Do not over-tighten the fixing screws.
8. Refit the Remote Keypad by slanting 45° onto
the wall mounting plate. Do not over-tighten the
fixing screw.
Note: The Remote Keypad is supplied with a default
User ccess Code of: 1234. For security reasons, it
is recommended that this code is changed to
another four digit number which only you and other
users of the system know.
Reset
Jumper
Link J2
lkaline battery to the
Note: Use thumb and middle finger to hinge off the
cover. The Remote Keypad has a back light illumination
facility. It will illuminate for 5 seconds when opening
the cover or pressing any key.

Inputting the House Code

In order to prevent any unauthorised attempt to
operate or disarm your system, you must configure
your system to accept radio signals only from your own
system devices. This is done by setting a series of
eight miniature (DIP) switches in all devices to the same
ON/OFF combination (The House Code) selected by the
user/installer. For security reasons, the Keypad does not
include a DIP switch, but house code setting is essential.
To input the house code, press the following keys in
sequence:
1. Press
?
2. Enter
User Access Code
3. Press , the
and flash twice
4. Press
?
House Code set on Devices
5. Press , the
and flash three times to confirm the setting has
been accepted.
For example: if the house code set on the devices
reads as: 12578. It means the Dip Switch numbers
1, 2, 5, 7, 8 are set to the "ON" position, while 3, 4, 6
are set to the "OFF" position.
set in "ON" positions for house code inputting.

Resetting to Factory Default

If you forget the User ccess code, you can reset the
User ccess code to factory default by following the
steps below:
1. Remove the battery.
2. Press and hold any key for more than 1 second.
3. Set the Jumper link J2 as shown in Fig. b below.
1
Fi g. a
8
? ? ?
LED will illuminate once
? ? ?
LED will illuminate once
pply the Dip Switchs
1
J 2 J 2
Fig. b