Digital Electronics Pro-face GP-377 Series User Manual page 94

Case Cross Section
7-2
Chapter 7 - Maintenance
Be sure to insert the gasket into
the groove so that the long side is
vertical.
Installation
Gasket
Groove
2) Insert the gasket into the GP's three
remaining corners, as shown in step 1.
• The gasket must be inserted
correctly into the groove for
t h e
resistance to be equivalent
to IP65f.
• The upper surface of the
g a s k e t s h o u l d e x t e n d
approximately 1.5mm out
from the groove. Be sure to
check that the gasket is
correctly inserted before
installing the GP into a
panel.
GP-377 Series Users Manual
G P ' s m o i s t u r e