Chapter 6 Gp Run Mode And Errors; Gp Run Mode; After Powering Up The Gp; Via Offline Mode - Digital Electronics Pro-face GP-377 Series User Manual

Chapter
6
This chapter describes both the GP RUN mode and GP problem solving processes.
6.1

GP RUN Mode

There are two ways of entering the GP's RUN mode; first, immediately after
plugging in the unit's power cord, and the other, from the GP's OFFLINE mode.

6.1.1 After Powering Up the GP

First, connect the GP's power cable. After the unit has powered up, the START
TIME value, set up in INITIALIZE area's SYSTEM SET UP feature, determines
how long the display shown below is shown. The screen designated in the INI-
TIALIZE area's SET UP SCREEN feature will then be shown and the GP will
start communicating with the PLC. If, however, a screen has not been designated
in the INITIALIZE area's SET UP SCREEN feature, or if the screen itself does not
exist, then this display will remain.

6.1.2 Via OFFLINE Mode

Touch the MAIN MENU's RUN selection to start your downloaded "project".
The INITIALIZE area's SET UP SCREEN feature designates the first screen that
appears in RUN mode, and, after this screen appears, communication with the
PLC begins. If, however, the designated initial screen has not been created, or
does not exist, the above display will remain.
GP-377 Series Users Manual
1. GP RUN Mode
2. Troubleshooting
3. SELF-DIAGNOSIS
4. Error Messages
GP RUN Mode and Errors
Protocol Name System Version
6-1