Chapter 3 Installation And Wiring; Installation; Installation Procedure - Digital Electronics Pro-face GP-377 Series User Manual

Chapter
3
3.1

Installation

3.1.1 Installation Procedure

Before installing the GP into a cabinet or panel, check that the installa-
tion gasket is securely attached to the unit.
Rear of GP
n n n n n Creating a Panel Cut Out
Create the correct sized opening required to install the GP, using the installation
dimensions given.
The installation gasket, installation brackets and attachment screws are all re-
quired when installing the GP.
• Check that the installation panel or cabinet's surface is flat, in good condition and
has no jagged edges.
• Panel thickness should be from 1.6mm (0.06in.) to 5.0mm (0.2in.).
Decide the panel's thickness based on the level of panel strength
required.
GP-377 Series Users Manual
Installation and Wiring
It is strongly recommended that you use the gasket since it
absorbs vibration in addition to repelling water.
Installation gasket
Place the PL on a level surface with the display panel facing
downward. Check that the GP's installation gasket is seated
securely into the gasket's groove, which runs around the
perimeter of the panel's frame. For details about installing
the gasket, refer to
2.5.3 "GP Panel Cut Out Dimensions"
Panel
Cut Out
Area
1. Installation
2. Wiring Cautions
3. GP Tool Connector
7.1.2 Installation Gasket Replacement
1.6mm(0.06in.) to 5mm(0.2in.)
3-1