Digital Electronics Pro-face GP-377 Series User Manual page 35

n n n n n Installation Direction
Insert the GP into the panel from its front face.
n n n n n Securing the Installation Fasteners
1) There are four (4) insertion slots on the top and bottom of the GP, where
the metal installation fasteners hook on.
Top/Bottom View
Installation fastener
2) Insert each of the fasteners into its slot as shown below. Be sure to pull the
fastener back until it is flush with the rear of the attachment hole.
3) Use a screw driver to tighten the attachment screws and secure the GP unit
in place.
A torque of only 0.5 to 0.6 N•m is required to tighten an attachment
screw. Do not use too much force, since it may damage the GP unit.
GP-377 Series Users Manual
Hook
Panel
Side View
Panel
Front Side
Insertion
Slot
Rear Side
3-3