Digital Electronics Pro-face GP-377 Series User Manual page 89

Chapter 6 - GP RUN Mode and Errors
n ILLEGAL ADDRESS IN SCREEN DATA
Caused by an overlap of addresses.
After the error message, error codes, as listed below will appear. If the error
cannot be fixed, please report the error code and details on how the error devel-
oped to your local GP distributor.
Overlapping Addresses
Overlapping addresses, other than the ones mentioned above, can also cause the
Illegal Address message.
E.g.
*1 For details about the T-tag (trend graph) and A-tag (alarm messages),
ation software)
GP-377 Series Users Manual
ILLEGAL ADDRESS IN SCREEN AREA (00B:XXX:XXX)
Error 1 Error 2
191
All or part of the T-tag
0C1 192
range overlap the addresses of System Data
Area.
193
194
All or part of the System Data Area address,
A-tag, or S-tag address range overlap the
0C2 195
addresses setup in a T-tag.
196
197
All or part of a T-tag
0C3 198
range overlap the address range set in an A-
tag (Alarm Message.)
199
All or part of a T-tag
0C9 19B
range overlap the address range set in an A-
tag (Log alarm.)
When the starting address of the System Data Area is set to 100, and the
tag below is setup:
Tag Name/ Part ID No.
N1
Starting from addresses 99, two(2) words are used, which causes it to
overlap address 100.
GP-PRO/PBIII for Windows Tag Reference Manual (included with the screen cre-
Error
No. 1
Meaning
*1
or S-tag address
*1
*1
, S-tag or K-tag address
*1
, S-tag or K-tag address
Word Address Tag Format
99 BCD32
Error No. 2
(Refer to Table
below)
6-17