Cleaning The Exchanger And The Compartment Underneath The Brazier Every 2/3 Days - RED Compact 24 Use And Installation Manual

red
Cleaning the exchanger and the compartment underneath the brazier
10.4.3.
every 2/3 days
Cleaning the exchanger and the compartment under the brazier is a
simple yet very important operation to ensure the performance
declared at all times.
Every two or three days, we therefore recommend you clean the
internal heat exchanger, following these few simple steps in order:
Lift the cover
o
Enable the "CLEANING" function – with the boiler switched
o
off, press the control panel button 4 shown in figure 7 for 2
seconds. This procedure starts the smoke blower on the
maximum setting to expel the soot that becomes dislodged
when the exchanger is cleaned.
Clean the pipe unit – Using the "hands cool" implement
o
provided, shake the rods situated under the cover vigorously 5-
6 times. This will remove any soot that has deposited on the
exchanger's smoke ducts during normal boiler operation.
Disable the "CLEANING" function - this function is
o
automatically disabled after two minutes. If you need to
interrupt this function earlier, press button 5 shown in figure 7.
Clean the smoke conveyor compartment (fig.9) - The
o
boiler is fitted with a removable ash tray designed to collect
any soot and ash build-up. When you have finished cleaning,
close the cover.
If this cleaning process is not performed every 2-
3 days, the boiler may trigger an alarm due to ash
build-up after several hours of operation.
Maintenance and cleaning
COMPACT 24 BOILER
USE AND MAINTENANCE MANUAL
ASH TRAY
2
SET
1
Figure 7 – "Cleaning" function
Figure 8 – Cleaning the internal pipe
unit using scrapers
Figure 9 - Cleaning the lower ash tray
Technical dept. - All rights reserved - Reproduction prohibited
Chapter
10
52
page
OFF
3
!
5
2041
:
6 4
TURBO
5
4