Installing A "Compact" Hot Water Boiler; General Warnings - RED Compact 24 Use And Installation Manual

red

4. INSTALLING A "COMPACT" HOT WATER BOILER

General warnings

4.1.
This boiler must only be used for the use expressly intended. Any other use is to be considered incorrect
o
and therefore dangerous.
This boiler is designed to heat water
o
These appliances are designed solely for installations in suitable rooms or technical premises.
o
Consequently, these appliances cannot be installed and operated outdoors. Outdoor installation could
lead to malfunctions and hazards. For outdoor installations, we advise you to choose an appliance
designed specifically for this purpose.
The boiler must NOT be used by children or unassisted persons with limited abilities.
o
Do NOT leave any packaging components within the reach of children or persons with limited physical,
o
sensory or mental skills or with little experience and knowledge.
Do NOT touch the boiler bare foot and with wet or damp body parts
o
The venting apertures are vital for correct combustion
o
After a prolonged period of inactivity, check for any obstructions before starting the boiler.
o
Do NOT block or reduce the size of the venting apertures of the room where the boiler is installed
o
Do NOT pull, detach or tamper with the electrical wires protruding from the boiler, even when the latter
o
is cut off from the electricity mains.
Caution: some parts of the boiler can get very hot; you are therefore advised to wear suitable heat
o
protection.
Do NOT modify the safety or regulating devices without the manufacturer's authorisation.
o
The door to the combustion chamber MUST remain shut during normal product operation
o
The boiler was designed to operate in any weather, yet in the case of adverse weather (strong wind,
o
ice), the safety systems may be triggered and shut off the boiler. If this is the case, contact the service
centre and do not override the safety devices.
In the event of fire in the flue pipe, call the fire brigade.
o
If the boiler shuts down, for reasons other than routine maintenance, call the service centre.
o
Before making the boiler connections, have professionally qualified staff perform the following:
o
a) Clean thoroughly all system piping to remove any residue or impurities which could compromise the
correct functioning of the boiler
b) Check that the chimney flue/flue pipe has a suitable draft, is free of any kinks, and that no outlets
from other appliances are introduced there.
The appliance must be installed by a qualified fitter with the required technical and professional
o
qualifications pursuant to Italian Law 46/90 and to Italian Ministerial Decree no. 37 of 22
who, under his own responsibility, shall guarantee compliance with the regulations of good practice.
The boiler must be connected to a heating system and/or to a domestic hot water production network,
o
compatibly with its performance and power.
Installation
COMPACT 24 BOILER
USE AND MAINTENANCE MANUAL
Technical dept. - All rights reserved - Reproduction prohibited
Chapter
4
13
page
nd
January 2008