red
9.4.4.1.
Start day (abbreviation on the display UT 01)
It is the current day which is set first and used as reference for the
programming sequence. To understand the full meaning, ask yourself:
what day is it today?
Let's suppose the day you read this paragraph is a Friday. With the
help of the table opposite (
to DAY 5. You will have to assign the value of DAY 5 as the start day
for the boiler.
To set this value, press buttons
"UT 01"
abbreviation
will be displayed, alternately with "OFF". Now
press the
button once to display "DAY 7". You will immediately see
that indicator light (9) on the display has lit up.
Press the
button twice more to display "DAY 6 DAY 5" in
sequence.
Now the display (8) alternates "DAY 5" with
The same procedure can be implemented using the
difference is that the menu scrolling is the other way around, i.e.:
"OFF DAY 1DAY 2DAY 3DAY 4DAY 5"
To store the setting, press the
IN SHORT:
To ENABLE the PROGRAMMED mode (indicator light 9 on), press
buttons
and
in sequence to display
buttons to decrease or increase the start day. To store, press the
button.
CAUTION!
Any day stored, with the exception of "OFF", enables
the PROGRAMMED mode.
To DISABLE the PROGRAMMED mode (indicator light 9 off), press the
and
buttons in sequence to display "UT 01". Then press the
buttons to display "OFF" and confirm by pressing the
Only the stored abbreviation "OFF" disables the
PROGRAMMED mode.
Clock (abbreviation on the UT 02 and UT 03)
9.4.4.2.
See paragraph 4.5.1. relating to the setting the current time to find out
how to set the current time.
The main steps are nonetheless summarised below.
Setting the HOURS (abbreviation on the UT 02)
Press the
and
parameter "UT 01", use the
which corresponds to the time on the clock expressed in HOURS.
The display (8) shows alternately the abbreviation "UT 02" and an
indication of the internal boiler time at that moment.
Use the
(increase) or
Programming and settings
COMPACT 24 BOILER
USE AND MAINTENANCE MANUAL
Figure 7
), you'll see that Friday corresponds
and
"UT 01".
button.
"UT 01"
buttons to access the set-up menu and
button to access parameter "UT02"
(decrease) buttons to adjust the hour.
in sequence. The
button; the only
. Then press the
or
or
button.
Technical dept. - All rights reserved - Reproduction prohibited
2
Ut 01
!
SET
63°C
1
6
Buttons for menu access.
2
Ut 01
!
SET
day5
1
6
Choosing the current day and enabling the
programmed mode.
Chapter
9
40
page
3
5
4
TURBO
3
5
4
TURBO
Need help?
Do you have a question about the Compact 24 and is the answer not in the manual?