socomec Asys 16 A Transfer System Installation And Operating Manual page 7

2. S
AfETy
I
2. 1.
mpORTANT
Read the following safety notices carefully! Failure to observe the instructions may en-
danger your life, your health, the reliability of your device or the security of your data.
– Transport the unit only in its original packaging.
– If the equipment is stored in a cold environment prior to installation, condensa-
tion may occur. Before you switch on the equipment it must be absolutely dry.
– The equipment must be installed in accordance with the environment conditions
specified as follows: Operating temperature: 0 to 40°C, Operation humidity: 20%
to 85% (no condensing).
– Lay all cables so that nobody can stand on them or trip over them.
– For pluggable equipment, the socket-outlet shall be installed near the equipment
and shall be easily accessible. The plug on the power supply cord is intended to
serve as the disconnecting device.
– Make sure that no objects get inside the device.
– The sum of the ASYS leakage currents does not exceed 3.5mA.
– Earth connection must be done prior to any connection to the power supply.
– Data transmission lines should NOT be connected or disconnected during a thun-
derstorm.
Do NOT connect equipment that will overload the ASYS.
E
2. 2.
mERGENCy
The supply to the load may be interrupted by opening both input power supply.
DO NOT use WATER to extinguish any fire that may occur in the area in which the
ASYS is installed.
ASYS
16 A Transfer System
IOMASY160810-GB_00
3