Panasonic KX-NCP500 Manual Manual page 82

4.1.8 DISA (Direct Inward System Access)
An outside party such as a cellular phone can transfer a CO line call to an extension at the PBX by
pressing "#" + extension number, if DISA is connected by the Automatic DISA Activation feature. This
feature can be enabled or disabled through system programming.
It is also possible to establish a Conference call (® 3.1.18 Conference), perform Call Splitting (® 3.1.9 Call
Splitting), and page with a call on hold to transfer the call (® 13.1.1 Paging).
7.3 [5-3-1] Voice Message—DISA System—Option 1
→
CO-CO with DISA—Transfer by DTMF "#" (Activation Key Required)
→
CO-CO with DISA—Return to DISA Top Menu by DTMF "*"
–
The KX-NCS3910 (Activation Key for Software Upgrade to Enhanced Version) is required to use this
feature.
–
DISA security mode should be set to No Security or CO Line Security.
–
If the called extension does not answer, is busy, or is in DND mode, the DISA Intercept feature operates.
–
The party on hold can use the Call Retry feature.
–
End of Call Detection does not operate after dialing "#".
–
Calls can only be transferred to extensions (not including floating extensions) within the PBX. If the
transferred call is forwarded to another outside destination, COS settings are ignored.
–
If the call is transferred to an ICD group, the call will wait in a queue until answered, but the Queuing
Time Table will not function.
–
When using this feature, do not use the Executive Busy Override feature to interrupt the established
call.
•
DISA Reorder Tone Duration
It is possible to set the DISA Reorder Tone Duration time. This specifies the length of time that a reorder
tone will be sent to the caller. When the timer expires, the call will be disconnected. Call Retry is possible
during the DISA Reorder Tone Duration time.
® 4.5 [2-3] Timers & Counters—DISA / Door / Reminder / U. Conf—
•
Call Deny
Extensions can deny DISA calls on a COS basis.
® 4.12 [2-7-1] Class of Service—COS Settings—Optional Device & Other Extensions—
from DISA
•
Verification Code PIN Lock/Extension PIN Lock
If the wrong PIN is entered three times, the line will be disconnected. If the wrong PIN is entered a
preprogrammed number of times successively, that extension or verification code will become locked, and
even entering the correct PIN will not unlock it. Only an extension assigned as the manager can unlock it.
In this case, the PIN will be unlocked and cleared.
® 4.5 [2-3] Timers & Counters—Miscellaneous—
•
DISA Automatic Walking COS
The KX-NCS3910 (Activation Key for Software Upgrade to Enhanced Version) is required to use this
feature.
•
Each outgoing message (OGM) can be assigned a name through system programming for programming
reference.
® 7.4 [5-3-2] Voice Message—DISA Message—
® [731] Outgoing Message (OGM) Name
Installation Manual References
3.7.1 OPB3 Card (KX-NCP1190)
3.7.5 MSG4 Card (KX-TDA0191)
3.7.6 ESVM4 Card (KX-TDA0194)
PC Programming Manual References
4.5 [2-3] Timers & Counters—DISA / Door / Reminder / U. Conf
82 Feature Manual
DISA—Reorder Tone Duration
Extension PIN—Lock Counter
Name
Accept the Call
Document Version 2009-12