Quick Start - CipherLab 2200 User Manual

QUICK START

The configuration of the scanner can be done by reading the setup barcodes (setup labels)
contained in this manual or via the ScanMaster software.
This section describes the procedure of configuring the scanner by reading the setup
barcodes and provides some examples for demonstration.
Note: If RS-232 or USB Virtual COM is selected for output interface, the host can directly
send serial commands to configure the scanner.
For example, run HyperTerminal.exe and type the 6-digit command located under
each setup barcode. Refer to Appendix II Host Serial
Update
Commands.
5