Dial Parameter And Connect Speed Displays (X) - Black Box 325 User Manual

MODEM 325 AND MODEM 325 CARD
6.6.5 D P
IAL ARAMETER AND
Command
X
X1
X2
X3
X4
†default
X followed by a dial command causes the modem to go off hook, wait the amount of time set in register
S6, and dial the number. If connection is made, the modem returns a CONNECT (code 1) message to
the screen regardless of the speed of connection. With a basic response, the modem will not detect a busy
or no dial tone condition.
X1 followed by a dial command causes the modem to go off hook, wait the amount of time set in
register S6, and dial the number. If connection is made the modem returns an appropriate CONNECT
message or code to the screen. The modem will not detect a busy or no-dial-tone situation.
X2 followed by a dial command causes the modem to go off hook and wait for a dial tone before
dialing. If a dial tone is not detected within 5 seconds, the modem sends a NO DIALTONE message and
hangs up. The modem will not detect a busy situation in this mode.
X3 followed by a dial command causes the modem to go off hook, wait the amount of time set in
register S6 and dial the number. If a busy signal is detected, the modem sends a BUSY message and
hangs up. If the call is completed, the appropriate CONNECT message similar to X1 will be displayed.
The modem will not detect a no-dial-tone situation.
X4 followed by a dial command causes the modem to go off hook and wait for a dial tone before
dialing. If a dial tone is not detected within 5 seconds, the modem returns a NO DIALTONE message
and hangs up. If a busy signal is detected, the modem returns a BUSY message and hangs up. If the call
is completed, the appropriate CONNECT message similar to X1 will be displayed.
The X4 command combines all the features of X2 and X3. The factory setting is X4.
6 0
C S
ONNECT PEED
Table 6-3. Dial Parameter and Connect Speed Displays (X).
D (X)
ISPLAYS
Description
Dial-tone and busy-signal detection not selected. CONNECT (code 1)
response messages displayed for all speeds.
Dial-tone and busy-signal detection not selected. Appropriate
CONNECT response messages or codes displayed for data rate.
Dial-tone detection only selected. NO DIAL TONE message or code
appears if dial tone is not detected within 5 seconds.
Busy-signal detection only selected. BUSY message or code
appears if dialed number is busy.
Dial-tone and busy-signal detection selected. The appropriate
CONNECT message or code is displayed.†