Table of Contents
Advertisement
MODEM 325 AND MODEM 325 CARD
3.1 General
This chapter provides information for the mechanical and electrical installation of the modem.
3.2 Site Selection
Install the modem within 6 feet of a 115- or 230-VAC grounded outlet as required for the specific model
and no farther than 50 feet from the terminal equipment.
The installation area should be clean and free from extremes of temperature, humidity, appreciable
shock, and vibration. Refer to
access and at least 4 inches at the rear for cables and air flow.
3.2.1 T
R
OOLS
EQUIRED
Normal installation requires a screwdriver to secure the DTE cable to the modem and to attach the telco
cable to the phone jack for leased-line operation.
3.2.2 R
I
ECEIPT
NSPECTION
After unpacking the equipment, check the contents against the packing list. Inspect the equipment for
any damage that may have occurred in shipment. If you note any damage or are missing equipment, call
your supplier. Keep the shipping container and material for future shipment.
3.3 Electrical Installation
The rear panel (
Figure 3-1
1 8
3. Installation
for details. Allow clearance for operation and maintenance
Chapter 1
) houses the power cord and connectors for the DTE and telephone lines.
AUX
LINE
Figure 3-1. Rear Panel I/O.
3/16
FUSE
AMP S.B.
DTE
115 VAC
60 HZ 14W
ON
POWER
OFF
Advertisement
Table of Contents
