Load Factory Options (&F); View Configuration Profiles/Received Signal Parameters (&V); Storing A Telephone Command Line (&Z) - Black Box 325 User Manual

MODEM 325 AND MODEM 325 CARD
6.12.3 L F
OAD ACTORY
The AT&Fn command is used to load the factory option sets. Refer to
each set.
Command
&F, &F1
&F2
&F3
&F4
†default
6.12.4 V C
IEW ONFIGURATION
Allows the user to view the current configuration profile in the form of S-register values. &V1 displays
the received signal parameters.
Table 6-41. View Configuration Profiles/Received Signal Parameters (&V).
Command
&V
&V1
6.12.5 S T
TORING A ELEPHONE
Nine stored phone number locations of up to 31 characters each are available in nonvolatile memory.
Normally, one phone number per location is accommodated. However, a phone number longer than 31
characters will overflow into the next location. Any spaces remaining in the overflowed location cannot
be used for another number. The stored phone number is retained until replaced by another number.
Modem power can be turned off without affecting stored information.
Two commands can store phone numbers:
AT&Zn—Stores telephone number n, including dial modifiers, at location 1 (up to 31 digits).
AT*CNx,n—Stores telephone number n, including dial modifiers, at location x (x=1 to 9).
Neither the AT prefix nor the D command should follow the &Z.
8 4
O (&F)
PTIONS
Table 6-40. Load Factory Options (&F).
Operation
Load factory option 1 (async dialup with MNP)†
Load factory option 2 (async dialup without MNP)
Load factory option 3 (sync dialup without MNP)
Load factory option 4 (sync 4-wire leased line without MNP)
P /R
ROFILES ECEIVED
Operation
Displays configuration profiles
Displays received signal parameters
C L
OMMAND INE
S P
IGNAL ARAMETERS
(&Z)
NOTE
for a complete list of
Appendix C
(&V)