Table of Contents
Advertisement
Command
\X
\X1
†default
6.14.6 MNP D
C
ATA
OMPRESSION
To enable data compression while running MNP protocol, enter AT%C1. To disable data compression,
enter AT%C.
Command
%C
%C1
†default
6.14.7 A
-R
UTO
ELIABLE
Selects the ASCII character to be recognized as the auto-reliable fallback character by the answering
modem. During negotiation of protocol in auto-reliable mode, the answering modem switches from
reliable to normal mode upon receipt of the auto-reliable fallback character from the calling modem and
passes the character to the serial port.
To set the auto-reliable fallback character, enter AT%An, where n=1 to 127 decimal representing an
ASCII character
The default of 0 disables auto-reliable fallback character.
Table 6-50. XON/XOFF Passthrough (\X).
Operation
Process but do not pass XON/XOFF characters to remote DCE†
Process and pass XON/XOFF characters to remote DCE
(%C)
Table 6-51. MNP Data Compression (%C).
Operation
Data compression disabled
Data compression enabled†
F
C
ALLBACK
HARACTER
CHAPTER 6: Asynchronous Operating Commands
(%A
)
N
8 9
Advertisement
Table of Contents
