Table of Contents
Advertisement
8.1 General
V.25 bis is an option that allows dialing functions to be controlled using synchronous data.
Select this option by the front panel LCD or by the appropriate &M command in the AT command set
(
).
see Section 6.11.12
If using the LCD:
• Scroll through the menu to Main Menu 5, MODIFY CONFIGURATION.
• Advance to and enter the DTE OPTIONS submenu.
• Select SYNC DATA.
• Advance to DIAL METHOD.
• Select either V.25 BISYNC DIALER or V.25 SDLC DIALER and then select either ASCII or EBCDIC
character format.
The modem must be configured as V.25 SDLC ASCII NRZ to use it with an IBM
computer.
A
C
UTODIALER
OMMAND
Most command strings for the autodialer include two parts: the command itself and the parameter(s)
that follow. For the purposes of this chapter, parameters can be telephone numbers or anything
appropriate to V.25 bis as described in the following text. Parameters are separated by semicolons.
For example:
PRN a; nnn . . . n (where a=the phone number address in memory and nnn . . . n = the phone number)
The a and the nnn . . . n are both parameters.
Not all commands have parameters. For example, the CIC command has no parameter.
8.2 Guidelines
Use the following guidelines when working with V.25 bis software:
• An indicator enclosed in angle brackets < > represents a specific character in the appropriate
character set, ASCII or EBCDIC.
<sp> - space
8. V.25 bis Autodialer
S
P
TRINGS AND
ARAMETERS
CHAPTER 8: V.25 bis Autodialer
NOTE
®
AS/400
®
119
Advertisement
Table of Contents
