Answer/Originate (*Or); Leased-Line Transmit Level (*Tln); Configuration Commands; Modem Power-On Configuration (&W) - Black Box 325 User Manual

MODEM 325 AND MODEM 325 CARD
6.11.28 A /O
NSWER RIGINATE
Forces modem to answer or originate mode. This option is used with 2 or 4-wire leased line operation
with error correction and/or dial backup.
Command
*OR
*OR1
†default
6.11.29 L -L
EASED INE
Command
*TLn
default is 0 dBm

6.12 Configuration Commands

These commands recall various profiles and insert them into the active profile, store the active profile and
telephone numbers in nonvolatile memory, and designate the powerup profile. Remote configuration is
discussed at the end of this section.
6.12.1 M P
ODEM OWER
The &W command stores the current modem configuration (or profile) options in nonvolatile memory.
The stored configuration is retained in memory, even when power is off, until &W is issued with a new
configuration or a factory configuration is restored with the &Fn command.
To store the current configuration, enter AT&W.
When the modem is reset with the Z command or power is turned on, the stored configuration becomes
the current configuration. Once a proven configuration is established, this command saves time.
To reset the modem, enter ATZ.
Enter the ATZ command to reset the modem and reinstate the power-on configuration stored in the
modem memory.
illustrates configuration storage and recall.
Figure 6-1
8 2
(*OR)
Table 6-37. Answer/Originate (*OR).
Operation
Force originate†
Force answer
T L (*TL
RANSMIT EVEL
Table 6-38. Leased-Line Transmit Level (*TLn).
Operation
Sets leased line TX level to n where n is a number between 0 and 15
corresponding to a TX level of 0 to -15 dBm
-O C
N ONFIGURATION
)
N
(&W)