Table of Contents
Advertisement
V.92 DIALUP 2-WIRE OR 4-WIRE LEASED-LINE DATA/FAX MODEM QUICK START GUIDE
Step 1: Connect the Modem to Your System
Power off your computer. Place the modem in a convenient location. Connect it to your computer's serial port,
the telephone line, the leased line, AC power, and to your telephone (optional). See Figure 1 for an illustration
of this setup. Detailed information on each connection appears below the diagram and on the following pages.
Telephone
PSTN wall jack
C
Y
PC
ONNECT TO
OUR
Plug one end of the serial cable into the RS-232 connector on the modem. Plug the other end into a serial port
connector on your computer, such as COM1 or COM2.
C
T
ONNECT TO THE
ELEPHONE
Plug one end of the modular phone cable into the modem's LINE jack. Plug the other end into a public
switched telephone network (PSTN) wall jack.
The LINE jack is not interchangeable with the PHONE jack. Do not plug the phone into
the LINE jack or the line cable into the PHONE jack.
Regulatory agencies may impose certain restrictions on equipment connected to
public telephone systems.
4
Modem Installation
V.92 Dialup 2-Wire or 4-Wire
Leased-Line Data/Fax Modem
Figure 1. Modem connections with V.92 transformer.
L
(D
C
INE
IALUP
ONNECTION
Power supply
Computer
)
CAUTION
NOTE
Advertisement
Table of Contents
