Table 3.15 Ports And Leds Of The Wim - Samsung OfficeServ 7200 Technical Manual

OfficeServ 7200
TECHNICAL MANUAL
Refer to the OfficeServ 7200 Data Server User Manual for WIM Configuration and Management
Information.
FRONT VIEW OF WIM
The front view of the WIM module is shown in the picture below.
The components on the front panel of the WIM have the functions below.
Ports & LEDs
P1, P2 & P3
P4
SERIAL
SIO
RST
RUN LED
P1, P2, P3, P4 and
LED
SERIAL LED
LAN LED
Figure 3.34 Front View of the WIM Board

Table 3.15 Ports and LEDs of the WIM

Function Description
10/100 Base-T Ethernet Interface Ports that may beset for LAN or WAN.
10 Base-T Ethernet Interface Port that may be set for LAN or WAN.
Port that connects to a dedicated serial line that may be set to LAN or
WAN. The V.35 cable can be ordered separately
outs).
Serial Console Access
Button for resetting the WIM module
This LED indicates the operation status of the WIM.
- Off: The WIM board is in an abnormal status or the power is not being
supplied.
- On: The WIM is operating properly.
These LEDs indicate the operational status of the Ethernet Port.
- Off: The link is connected.
- On: The link is not connected.
- Flashing: Data is being transmitted or received.
This LED indicates the operation status of V.35 connection.
- Off: The link is not connected to a network using this interface.
- On: The link is connected to a WAN or LAN.
This LED indicates the Operation Status of the LAN
- Off: Link is not connected to LAN.
- On: Link is in connected to LAN.
3.32
Home Page
INSTALLATION
PART 3 MAY 2010
(See Figure 3.34 for pin
Table of Contents