Samsung OfficeServ 7200 Technical Manual page 30

OfficeServ 7200
TECHNICAL MANUAL
• Miscellaneous (MIS): The MIS is installed in the first position of the MCP/MP20 (towards
front of the board). MIS provides 2 external Music On Hold ports, an external paging port,
a loud bell port, a common bell port, and also provides 2 dry contact relay ports that
connect or disconnects the signal transmission or power supply with external equipment.
• RCM: This board has a slide switch to switch between R2 and CID. This switch should
always be in the CID position. R2 signaling is not used in the USA. The RCM board installs
in the middle position on the MCP/MP20 card. The RCM board is used to provide 14 Caller
ID DSP circuits for Caller ID detection on loop start trunks.
• RCM2: This board performs the same function as the RCM, analog Caller ID (CID) decoding
on incoming calls. In addition, the RCM2 provides CID or FSK signaling on analog ports.
Any CID compatible device connected to analog station ports can display CID name and
number information as received from the telephone company. This board regenerates CID
exactly as the central office sends it.
This RCM2 board can be used in place of the RCM. Use MMC 300 to set CID to SLT "ON" for
each analog port that will have CID.
This board has a slide switch to switch between R2 and CID. This switch should always be
in the CID position. R2 signaling is not used in the USA. The RCM2 board installs in the
middle position of the MCP/MP20 card. The RCM2 board is used to provide 14 Caller ID
DSP circuits for Caller ID detection on loop start trunks.
• MODEM: The MP20 processor card has a modem slot that supports Samsung's universal
modem. The modem installation will be in position 3 of the card. It will leave only position
2 for a CRM, RCM, RCM2 or MFM card.
Mount the MODEM on MP20 only as shown below:
Figure 3.10 Installing Optional Modem Daughtercards on MP20 only
MODEM
3.12
Table of Contents
Home Page
INSTALLATION
PART 3 MAY 2010