Table 3.4 Ports And Leds Of The Mcp/Mp20 - Samsung OfficeServ 7200 Technical Manual

OfficeServ 7200
TECHNICAL MANUAL
The MCP/MP20 front panel components have the functions below:
Ports & LEDs
LINK1~LINK3
MISC1~MISC2
Smart Media /
Media Card / SD
Card
LAN
SIO
RST
RUN LED
LAN LED
PSC
SM LED
MC LED
LCP LED

Table 3.4 Ports and LEDs of the MCP/MP20

Function Description
Ports that connect the MCP/MP20 to the LCP.
Ports that connect external music sources, paging device, loud bell,
common bell, door bell when the optional MIS daughter board is
installed.
Disk drive for installing the 32MB Smart Media/64MB MMC+/1GB SD
card. This card contains the main system software.
Port for establishing the 10 Base-T/100 Base-Tx Ethernet connection.
Serial port (Samsung Engineering Use ONLY).
Button for resetting the MCP/MP20 board.
This LED indicates the status of the MCP/MP20.
- Off: Power is not connected.
- On: Booting
- Blink: The program is operating properly
This LED indicates the status of the connection to LAN.
- Off: MCP/MP20 is not connected to LAN.
- On: MCP/MP20 is connected LAN.
- Blink: MCP/MP20 is transmitting or receiving Data through LAN port.
Connection to the optional OS7150 Alarm Port.
This LED indicates the status of the Smart Media or Media Card access.
- Off: The MMC+/Smart Media/SD card is not installed.
- On: The MMC+/Smart Media/SD card is installed, however is not
accessed.
- Blink: The MMC+/Smart Media/SD card is installed and is being
accessed.
This LED indicates the status of signaling message processing.
- Off: There is no message exchange between MCP/MP20 and LCP.
- On: Messages are being sent/received to/from the LCP.
3.10
Table of Contents
Home Page
INSTALLATION
PART 3 MAY 2010