Table 2.5 Ports And Leds Of Mp10/10A/11 Boards - Samsung OfficeServ 7100 series System Description

CHAPTER 2. Ошибка! Используйте вкладку "Главная" для применения 제목 1,장 제목 1 к тексту, который должен
здесь отображаться.
The components on the front panel of the MP10/10a/11 boards have the functions below:
Ports and LEDs
P1~P4
MISC
LAN
WAN
SIO
Media Card
RUN LED
LAN LED
WAN LED
MC LED
RST
Caution for Media Card(MMC+/SD card)
If possible, don't remove the Media Card.
After dismounting Media card by MMC 817, eject Media card or power off if
necessary. Otherwise, Media card may be damaged.
After dismounting operation, MC LED is off. (MP10a/11)
When MC LED is red, remove the Media card and insert it again. (MP10)
2-8

Table 2.5 Ports and LEDs of MP10/10a/11 Boards

Subscriber connection port of 4DLMI/4SWM
Port to connect Ext PAGING, DRY CONTACT and Ext MOH
Port to connect 100 BASE-T LAN
Port to connect 100 BASE-T WAN (only MP11)
Port connect to serial I/O for development tool
Port to insert an MMC+/SD card, which is a storage media
Status of Main CPU operation
- Off: No-power
- On (Green): On Booting, Reset
- Blink (Green): Normal Operation of Program
- Blink (Red): Fan module failed Operation of Program
- Blink (Orange): Push the reset button under the 7sec (MP10a, MP11)
- On (Orange): Push the reset button over the 7sec, DB clear (MP10a, MP11)
Status of LAN operation
- Off: Link and no-connection of LAN port
- On (Green): Link and LAN port connection
- Blink (Green): Tx/Rx Data through LAN port.
Status of WAN operation (MP11)
- Off: Link and no-connection of WAN port
- On (Green): Link and WAN port connection
- Blink (Green): Tx/Rx
Status of MMC+/SD card operation
- Off: Non-mounted MMC+/SD card
- On (Green): Mounted MMC+/SD card
- Blink (Green): In Tx/Rx of MMC+/SD card
- On (Red): If the Media card is installed but not detected
Button for resetting board and DB clearing.
Functions
© SAMSUNG Electronics Co., Ltd.