Table 3.4 Ports And Leds Of The Mcp Board - Samsung OfficeServ 7200 Technical Manual

OfficeServ 7200
TECHNICAL MANUAL
3.2.4 MCP LEDs
The front view of the MCP board is shown in the picture below.
The MCP front panel components have the functions below:
Ports & LEDs
LINK1~LINK3
MISC1~MISC2
SmartMedia
LAN
SIO
RST
RUN LED
LAN LED
Figure 3.7 Front View of the MCP

Table 3.4 Ports and LEDs of the MCP Board

Function Description
Ports that connect the MCP with the LCP .
Ports that connect external music sources, paging device, loud
bell, common bell, door bell when the optional MIS daughter board
is installed.
Port for installing the 32MB Smart Media card. This card contains
the main system software.
Port for establishing the 10 Base-T/100 Base-Tx Ethernet
connection.
Serial port (Samsung Engineering Use ONLY).
Button for resetting the MCP board.
This LED indicates the status of the MCP .
- Off: Power is not connected.
- On: Booting
- Blink: The Program is operating properly
This LED indicates the status of the connection to LAN.
- Off: MCP is not connected to LAN.
- On: MCP is connected LAN.
- Blink: MCP is transmitting or receiving Data through LAN port.
3.7
Table of Contents
Home Page
INSTALLATION
PART 3 SEPTEMBER 2005