Table of Contents
Advertisement
< RS485 Setup >
This menu allows users to set up the parameters of the unit's RS-485 communication port.
From the System Setup menu, select <RS485 Setup> and press ENTER. The following
menu is displayed.
1. Unit ID
2. Baud Rate
3. Bits
4. Stop
5. Parity
Unit ID
This item is used to change the RS-485 ID address of the unit. The ID is in the
range of <1> to <255>. The default is <224>.
Baud Rate
The Baud rate options associated with the protocol are <2400>, <4800>,
<9600>, <19200> and <38400>. The default is <9600> baud.
Bits
The bits options associated with the protocol are <6>, <7> and <8> bits. The
default is <8> bits.
Stop
The stop bit options associated with the protocol are <1> and <2> stop bits.
The default is <1> stop bit.
Parity
The parity options associated with the protocol are <ODD>, <EVEN>, and
<None>. The default is <None>.
< Audio Output/ Key Beep >
Enter this item to setup the audio output or key beep.
1. Audio Output
2. Key Beep
RS485 Setup
Audio Output/Key Beep
User's Manual
224
9600
8
1
None
Live/PB
ON
40
Advertisement
Table of Contents
