Table of Contents
Advertisement
Termination
This item is used to enable / disable the 75-termination resistor inside the unit
to adjust the image quality of each camera. <Yes>= termination resistor
enabled, <No> = termination resistor disabled.
NOTE: If the camera loop-out connectors have not been used, the
termination resistor should be enabled for appropriate signal
termination.
Brightness
Move the cursor to the item and press ENTER for adjusting the brightness of
the camera. Use UP / DOWN keys to adjust the numeric value. The range of
brightness values is <-128> to <127>.
Contrast
Move the cursor to the item and press ENTER for adjusting the contrast of the
camera. Use UP / DOWN keys to adjust the numeric value. The range of
contrast values is <-128> to <127>.
Saturation
Move the cursor to the item and press ENTER to adjust the color saturation of
the camera by using UP / DOWN keys. This value will be ignored on
monochrome monitors. The range of saturation values is <-128> to <127>.
Hue
Move the cursor to the item and press ENTER for adjusting the hue of the
camera. Use UP / DOWN keys to adjust the numeric value. The range of hue
values is <-128> to <127>.
Audio Association
The item is used to establish the connection between the selected camera
and it's corresponding audio-in channel. Move the cursor to <Audio
Association> in Camera Setup menu and press ENTER, then select <Yes> or
<No> by UP / DOWN keys to set up the connection.
User's Manual
48
Advertisement
Table of Contents
