Chapter 4
Installing the Shipping Bracket on the UPS
Shipping the UPS in a Rack
The procedures in this chapter apply to a UPS that is shipped assembled
in a rack cabinet.
Shipping bracket
You must install the shipping bracket on the front of the UPS before the
UPS is shipped installed in a rack cabinet. The shipping bracket provides
extra protection for the UPS during shipment.
To install the shipping bracket:
1.
If the UPS front covers are installed, remove the covers. Press the
two side latches toward each other to release the cover, and pull
the cover away. Repeat for the second cover. Keep the covers.
2.
If not already disconnected, disconnect the UPS internal batteries.
Eaton 9910 UPS and EBM Installation Guide (6000 VA Models)
100%
1500
208V/60hz
VA
6 mi
UPS ON
n
O K
Figure 16. Shipping Bracket
S
P-164000007 Rev 1
33