Recovery Tank; Assembling The Brush - COMAC Vispa 35E Use And Maintenance Manual

ATTENTION: Acid or alkaline detergents can be used with pH values between
4 and 10 and that do not contain: oxidising agents, chlorine or bromine,
formaldehyde, mineral solvents.
ATTENTION: always use detergents whose manufacturer's label indicates
their suitability for scrubbing machines. Do not use acid or alkaline products or
solvents without this indication.
always use low foam detergent. To avoid the production of foam, before
starting to clean, put a minimum quantity of antifoam liquid into the recovery
tank. Do not use pure acids.
WARNING: you are advised to always wear protective gloves in order to
avoid the risk of serious injury to your hands

9. RECOVERY TANK

Make sure the recovery tank is empty, otherwise empty it completely.
Verify that the recovery tank is correctly inserted in its housing, and that the tubes are correctly
inserted in the tank elbows.
Verify that the caps are correctly closed.

ASSEMBLING THE BRUSH

To insert the brush:
1. Connect the machine to the mains power supply
2. Place the brush in front of the base body
3. Raise the base using the handlebars as a lever
4. Place the base above the brush
5. Activate the handlebar tilt lever
6. Press the main switch to turn on the machine
7. Pulse press the man present lever to engage the brush to the base
MACHINE PREPARATION
10