At The End Of The Work - COMAC Vispa 35E Use And Maintenance Manual

At the end of the work, and before carrying out any type of maintenance, perform the
following operations:
1. Turn off the solenoid valve switch (3)
2. Raise the squeegee by means of the rear handle (4)
3. Turn off the suction switch (2)
4. Turn off the main switch (1)
5. Disconnect the power cable from the socket
6. bring the machine to the place provided for draining the water
7. Detach the tubes and remove the recovery tank
8. Disconnect the hook securing the recovery tank on the rear of the machine.
9. Remove the recovery tank.
10. empty the recovery tank by removing the caps and tilting it
11. disassemble the brush and clean it with a jet of water (to disassemble the brush, see
"DISASSEMBLING THE BRUSH" below)
WARNING: this operation must be carried out wearing gloves to
protect against contact with dangerous solutions.

AT THE END OF THE WORK

13