Work; Preparing To Work; Overflow Device - COMAC Vispa 35E Use And Maintenance Manual

1. PREPARING TO WORK

Certain operations must be carried out before starting any work:
4. Verify that the tanks are properly inserted in the housings and connected.
5. verify that the switches are in the off ("0") position
6. connect the cable to the socket
ATTENTION: Verify that the electricity socket has a protective
conductor (or an earth conductor).
ATTENTION: Verify that the power supply voltage and frequency
comply with the nominal values required by the machine.
ATTENTION: Verify that the power supply cable is in perfect
condition.
7. carry out the operations to prepare the machine
8. lower the squeegee command lever in order to start working
9. press the main switch (1) and check the green indicator light comes on
10. press the suction switch (2) and check the green indicator light comes on
11. press the solenoid valve switch (3) and check the green indicator light comes on
At this point, the machine can work efficiently until the detergent solution runs out; use
the operating lever that activates the brushes (4)

2. OVERFLOW DEVICE

The machine is fitted with a ball filter which is activated when the recovery tank is full, causing
the suction tube to close.
In this case, you must switch off the machine and empty the recovery tank.
WARNING: this operation must be carried out by wearing gloves to
protect against contact with dangerous solutions.

WORK

11