Cleaning The Squeegee; Replacing The Squeegee Rubbers - COMAC Vispa 35E Use And Maintenance Manual

2. CLEANING THE SQUEEGEE

Check the squeegee rubbers are always clean, for a better drying action.
To clean them you must:
1. raise the machine
2. carefully clean inside
3. carefully clean the squeegee rubbers
ATTENTION: this operation must be carried out by wearing gloves in
order to protect against contact with dangerous solutions.
WARNING: Before carrying out any type of maintenance, disconnect
the machine's power supply cable.

3. REPLACING THE SQUEEGEE RUBBERS

Verify that the state of wear and tear of the squeegee rubbers and, if necessary, replace
them. To replace them you must:
1. Raise the squeegee
2. Remove the two knobs
3. disassemble the squeegee from its support
4. Remove the tube from the squeegee nozzle so the squeegee can be removed
ATTENTION: this operation must be carried out by wearing gloves in
order to protect against contact with dangerous solutions.
WARNING: Before carrying out any type of maintenance, disconnect
the machine's power supply cable.
5. unscrew the knobs on the squeegee that block the rubber-pressing blades, and remove
them
6. remove the rubber-pressing blades
7. replace the rubbers
8. reassemble everything, carrying out the above-mentioned operations in the reverse order
ATTENTION: this operation must be carried out by wearing gloves in
order to protect against contact with dangerous solutions.
WARNING: Before carrying out any type of maintenance, disconnect
the machine's power supply cable.
DAILY MAINTENANCE
15