Additional Items Required; Tools And Supplies Needed - Seagull Models GROB TUTOR G115 Assembly Manual

KIT CONTENTS.
1 Fuselage
2 Canopy
3 Left wing panel
4 Right wing panel
5 Tail set
6 Aluminum wing tube
7 Scale pilot
8 Seat (2)
9 Landing gear
10 Wheels (3)
11 Fuel tank
12 Nose gear
13 Wheel pants (3)
14 EP conversion pack
15 Hardware bag included
16 Fiberglass cowl

ADDITIONAL ITEMS REQUIRED.

0.46-0.55 2-stroke engine
0.72 -0.82 4-stroke engine
6 channel with 7 servos
Glow plug to suit engine
Propeller to suit engine
Protective foam rubber for radio
system
Silicone fuel line
TOOLS & SUPPLIES NEEDED.
Thick cyanoacrylate glue
30 minute epoxy
5 minute epoxy
Hand or electric drill
Assorted drill bits
Modelling knife
Straight edge ruler
2mm ball driver
Phillips head screwdriver
220 grit sandpaper
90° square or builder's triangle
Wire cutters
Masking tape & T-pins
Thread-lock
Paper towels
www.seagullmodels.com
Note:
the wing panels. Note the position of the hinges.
and flap and place a T-pin in the center of each
hinge. Slide each hinge into the aileron until
the T-pin is snug against the aileron. This will
help ensure an equal amount of hinge is on
either side of the hinge line when the flap is
mounted to the wing panel.
there is only a slight gap. The hinge is now
centered on the wing panel and flap. Remove
the T-pins and snug the flap against the wing
panel. A gap of 1/64" or less should be
maintained between the wing panel and flap.
HINGING THE FLAP .
The control surfaces, including the
ailerons, elevators, and rudder, are
prehinged with hinges installed, but
the hinges are not glued in place. It
is imperative that you properly
adhere the hinges in place per the
steps that follow using a high-quality
thin C/A glue.
1) Carefully remove the flap from one of
2) Remove each hinge from the wing panel
Hinge.
3) Slide the flap on the wing panel until
T-pin.
3