Fuel Tank Installation; Installing The Fuselage Servos - Seagull Models GROB TUTOR G115 Assembly Manual

FUEL TANK INSTALLATION.

You should mark which tube is the vent
and which is the fuel pickup when you attach
fuel tubing to the tubes in the stopper. Once
the tank is installed inside the fuselage, it may
be difficult to determine which is which.
7) Slide the fuel tank into the fuselage.
Guide the lines from the tank through the hole
in the firewall.
Tie wrap.
8) Use plywood template to hold in place the
fuel tank with C/A glue to secure the fuel tank
inside the fuselage.
Balsa wood included
9) Use balsa stick to help prevent moveable
from transferring to the fuel tank.
www.seagullmodels.com
10) Connect the lines from the tank to the
engine and muffler. The vent line will connect
to the muffler and the line from the clunk to the
carburetor.
Fuel tank.
sure the fuel lines have not become kinked
inside the fuel tank compartment. Air
should flow through easily.
Fuel tank.
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of the
mount allow the servo lead to pass through.
Epoxy
vided with your radio system.
Fuel pick-up tube.
Blow through one of the lines to en-

INSTALLING THE FUSELAGE SERVOS.

Because the size of servos differ, you
1) Install the rubber grommets and brass
collets onto the throttle servo. Test fit the servo
into the aileron servo mount.
2) Secure the servos with the screws pro-
vent tube.
Fuel fill tube.
11