Christie Mirage M Series Setup Manual page 19

Mirage m series
Hide thumbs Also See for Mirage M Series:
Table of Contents

Advertisement

F
2-8 C
IGURE
5. Fine tune the focus of cross-hair pattern I by adjusting the appropriate capscrew, see
until the cross-hair image is in focus with minimal flare.
6. Adjust cross-hair pattern II, by adjusting the appropriate capscrew, see
hair image is in focus with minimal flare.
7. Adjust cross-hair pattern III, by adjusting the appropriate capscrew, see
hair image is in focus with minimal flare.
8. Repeat step 5, 6, and 7 as required until all 3 cross-hair patterns are in equal sharp focus. If the boresight is
acceptable, see step 11. If the boresight does not appear to be converging to an acceptable level of image
quality or if the lens will not focus over the correct range of throw distances, then the boresight requires
coarse adjustment, see step 9.
9. The original factory boresight can be recovered approximately by positioning the 3 setscrews, see
2-9. Position the setscrews flush with the front face of the lens mount plate and in contact with the inner
lens mount plate, see below
10. If further action is required. Repeat #2.
11. Lock the setscrews, and re-check the boresight quality. Tighten the setscrew enough to ensure they will not
shift.
Mirage M Series Setup Guide
020-100592-02 Rev. 1 (11-2010)
-H
P
ROSS
AIR
ATTERN
Figure
2-10. This may require adjusting both setscrews and capscrews.
Section 2: Installation and Setup
F
2-9 S
L
IGURE
CREW
OCATIONS
Figure 2-9.
Figure
2-9. Adjust until the cross-
Figure
2-9. Adjust
Adjust until the cross-
Figure
2-7

Advertisement

Table of Contents
loading

Table of Contents