Christie Mirage M Series Setup Manual page 36

Section 3: Operation
CONNECTING THE 3D STEREO SYNC CABLE
This GPIO cable provides the means for synchronizing the various components in your 3D system. Your
source, projector display output, and emitters or 3D passive filter system can then operate together with
precision to minimize cross-talk and color artifacts. Connect as shown below in
Mirage M Series models, inputs A and B are not required, but recommended to ensure that stereo is configured
correctly, especially for multiple projector setups.
Connecting Two Stereo 3D Sync Inputs (Recommended for multiple sources). Connect your video card's
stereo 3D sync cable to either Input A or either Input B on the 3D Stereo Sync Cable. These inputs are
provided to allow you to connect two different Stereo 3D sources and conveniently switch the display back-
and-forth between them.
Connecting One Stereo 3D Sync Output, connect the 3D Stereo Sync Cable output to your stereo 3D sync
emitter or 3D passive filter system.
3-14
Figure 12 - Mirage M Series 3D Stereo Sync Cable
Figure 12. NOTE: For
Mirage M Series Setup Guide
020-100592-02 Rev. 1 (11-2010)