Safety Warnings And Guidelines; General Precautions; Ac /Power Precautions; Lamp Precautions - Christie Mirage M Series Setup Manual

1.2

Safety Warnings and Guidelines

1.2.1 General Precautions

1.2.2 AC /Power Precautions

1.2.3 Lamp Precautions

Mirage M Series Setup Guide
020-100592-02 Rev. 1 (11-2010)
FIRE HAZARD. Keep hands, clothes and all combustible material away from the
concentrated light beam of the projector. Position all cables where they cannot
contact hot surfaces or be pulled or tripped over.
All installation and maintenance procedures must be performed by a Christie
accredited service technician.
Projector must be operated in an environment that meets operating specifications, as
Section 6 Specifications
listed in
Use only the AC power cord supplied. Do not attempt operation if the AC supply and
cord are not within the specified voltage and power range. Refer to the license label
on the back of the projector or
The projector is equipped with a 3-wire plug with a grounding pin. This is a safety
feature. If you are unable to insert the plug into the outlet, contact an electrician to
have the outlet replaced. NEVER defeat the safety purpose of the grounding-type
plug.
Do not allow anything to rest on the power cord. Locate the power cord where
persons walking on it or objects rolling over it cannot damage the cord.
Never attempt to access the lamp while the lamp is ON. After turning the lamp OFF, it
is crucial that you wait at least 10 minutes before handling the lamp. This provides
sufficient time for the lamp cooling fans to properly cool the lamp. For all other
precautions critical for safe removal and replacement of the lamp.
Do NOT look into the lens
.
Section 6 Specifications
Section 1: Introduction
for rated voltage and power.
1-3