Lamps; Status Led; Electronics/Sw - Christie Mirage M Series Setup Manual

Section 6: Specifications

6.2.10 Lamps

Dual Mercury lamp system

6.2.11 Status LED

Status LED's
Lamp 1, Lamp 2
Power
Shutter

6.2.12 Electronics/SW

FEATURE
Video Format Re-Sizing
Picture in Picture
Seamless Switching
Built-in 2D keystone and geometry correction
Auto-scaling
Auto-de interlacing
Edge blending
Warping
Tiling (support for up to 3x3 arrays)
Blanking and Image positioning
Brightness, contrast, color, and uniformity
user settable control
Image orientation
Electronics HW access
Number of option cards
Number of processor cards
Number of option slots
Native format adjustment
Arbitrary Gamma
6-6
Lamps are accessed from side of projector
Lamps are individually swappable while the
projector is running
Located at back of projector
Off – Lamps are off
Yellow – Lamp time has expired and lamp should be replaced
Green – Lamp is on and operating correctly
Flashing red – Lamp has malfunctioned
Off – AC power is off
Yellow – AC is present but projector is in standby
Green – Projector is powered up and operating normally
Flashing green/yellow – Projector communication in progress
Flashing red – Error has occurred. Details are displayed on the status display
Green – shutter is open
Yellow – shutter is closed
COMMENTS
All video formats can be resized to fill screen either horizontally or
vertically while maintaining aspect ratio
Can display image front/rear, normal/inverted (ceiling)
All accessible electronics are mounted from the back of the projector
6 user inter-changeable – hot swappable
2 user inter-changeable
4, located at back of projector for option cards; 1, located at back of
projector for processor card
Optional global aspect ratio setting can be set for projector allowing for
automatic scaling of all input images to required output format
User definable gamma curves
LED STATES
Mirage M Series Setup Guide
020-100592-02 Rev. 1 (11-2010)