Installing The Horizontal Stabilizer - Seagull Models GEEBEE ARTF Instruction Manual

Masking tape.
3) Peel off the backing from the self adhe-
sive covering strip. Apply the strip to the centre
section of the wing starting from the bottom
trailing edge. Wrap the strip all the way around
the wing until it meets the trailing edge again.
Trim off any excess strip.

INSTALLING THE HORIZONTAL STABILIZER.

Remove the covering.
www.seagullmodels.com
Center line.
Hinge slot.
Pen.
When cutting through the covering to
remove it, cut with only enough pressure
to only cut through the covering itself. Cut-
ting into the balsa structure may weaken
it.
Remove covering.
Epoxy.
13