Wing Assembly - Seagull Models GEEBEE ARTF Instruction Manual

GEEBEE.
Wing
.
Aileron
.
Wing.
Repeat the procedure for the other wing.

WING ASSEMBLY.

NOTE: We highly recommend using 30
minute epoxy as it is stronger and provides
more working time, allowing the builder to
properly align the parts. Using fast cure epoxy
when joining the wing halves could result in the
glue drying before the wing halves are aligned
properly which may result in failure of the wing
centre section during flight.
1) Test fit the wing tube into each wing half.
The brace should slide in easily up to the
centreline that you drew. If not, use 220 grit
sandpaper with a sanding block and sand
down the edges and ends of the brace until it
fits properly.
Masking tape.
12
Wing
.
M2 lock nut.
Aileron.
Instruction Manual
Epoxy.
2) Remove the brace when satisfied with its
fit ineach wing half. Coat the dihedral brace
with 30 minute epoxy. Next, pour some epoxy
into the dihedral box in one wing panel. Make
sure you cover the top and bottom as well as
the sides of the dihedral brace.Use enough
epoxy to fill any gaps.
Epoxy.
Carefully slide the two wing halves together
and firmly press them together, allowing the
excess epoxy to run out. There should not be
any gap in the wing halves. Use rubbing
alcohol and a paper tower to clean up any
excess epoxy.
Apply masking tape at the wing join to hold
the wing halves together securely.
Aileron
.
Epoxy.