Preflight Check - Seagull Models GEEBEE ARTF Instruction Manual

F) From behind the airplane, look at the
aileron on the right wing half. Move the aileron
stick to the right. The right aileron should move
up and the other aileron should move down. If
it does not, flip the servo reversing switch on
your transmitter to change the direction.

PREFLIGHT CHECK.

1) Completely charge your transmitter
and receiver batteries before your first day of
flying.
2) Check every bolt and every glue joint
in the GEEBEE to ensure that everything is
tight and well bonded.
3) Double check the balance of the air-
plane. Do this with the fuel tank empty.
www.seagullmodels.com
move in the correct direction and not bind in
any way.
with dual rate switches double check that they
are on the low rate setting for your first few
flights.
are moving the proper amount for both low
and high rate settings.
be fully extended and not coiled up inside the
fuselage.
of balance propeller will cause excessive vi-
bration which could lead to engine and/or air-
frame failure.
We wish you many safe and enjoyable
flights with your
4) Check the control surfaces. All should
5) If your radio transmitter is equipped
6) Check to ensure the control surfaces
7) Check the receiver antenna. It should
8) Properly balance the propeller. An out
GEEBEE
.
25