Seagull Models GEEBEE ARTF Instruction Manual page 15

INSTALLING THE MAIN GEAR WIRES.
Remove the covering.
Wing botom.
Wing botom.
www.seagullmodels.com
9mm.
11mm.
.
M3 x 30mm
Spring landing gear.
1
1) Using a modeling knife, remove the
covering from over the two main gear mount-
ing slots located in the bottom of the wing.
2) Insert the 90º bend of one main gear
wire into the predrilled hole in one mounting
slot.
3) Using the two landing gear straps as a
guide, mark the locations of the four 3 x 10mm
mounting screws onto the wing surface.
Install the landing gear.
M3x15mm.
1
15