Jam Conditions; Error Detection - Ricoh B051 Service Manual

DETAILED SECTION DESCRIPTIONS

2.2.3 JAM CONDITIONS

Remaining paper detection
Non-feed at the entrance
Jamming at the entrance
Non-feed inside the unit
(Straight feed out mode only)
Jamming at the exit
Jogger tray

2.2.4 ERROR DETECTION

Jogger motor error
Jogger motor home position
detection error
Stapler error
Output tray upper limit error
Output tray motor error
Stack height detection error
NOTE: The above errors are indicated as "Finisher jam" at the first occurrence.
If the same error happens again in the next job, "finisher error" is indicated.
B458
CÓPIA NÃO CONTROLADA
Sensors
Entrance Either the entrance or exit sensor detects
Exit paper just after the unit is initialized.
The entrance sensor is not activated within a
Entrance certain period after the paper exit sensor
detects paper.
The entrance sensor is not de-activated after
Entrance paper is fed 1.3 times the length of the
paper.
The exit sensor is not activated within a
Exit certain period after the entrance sensor
detects paper.
The exit sensor is not de-activated after
Exit
paper is fed for a certain period.
The exit sensor is de-activated during paper
Exit
shifting or stapling.
The jogger home position sensor does not shut off after the
jogger motor starts.
The jogger home position sensor does not turn on after
paper shifting.
The stapler home position sensor (inside the stapler unit)
does not turn on after stapling.
The tray upper limit sensor is activated.
The output tray is away from the target position for more
than 10 seconds.
The stack height detection lever does not return to its home
position before going to detect the stack height.
20
CÓPIA NÃO CONTROLADA
Conditions
Conditions
SM