SERVICE PROGRAM MODE
No.
What It Initializes
11
NCS
(Network Control Service)
12
R-FAX
14
DCS
15
UCS
5. Touch EXECUTE, and turn the main switch off and on.
6. Download the NVRAM data from a flash memory card (☛ 5.2.2).
Without Using a Flash Memory Card
If there is no flash memory card, follow the steps below.
1. Execute SP5-990 to print out all SMC data lists.
2. Open SP5-801.
3. Select the number for the item that you want to initialize.
4. Press EXECUTE and turn the main switch off and on.
5. Make sure that you do the following:
• Do the printer and scanner registration and magnification adjustments (☛
"Copy Adjustments" in chapter 3, "Replacement and Adjustment").
• Do the touch screen calibration (☛ "Touch Screen Calibration" in chapter 3,
"Replacement and Adjustment").
• Referring to the SMC data lists, re-enter all values that have been changed
from their factory settings.
• Do the white level adjustment (☛ Section 3.14 Standard White Density
Adjustment)
6. Check the copy quality and the paper paths, and do any necessary
adjustments.
B051/B052
CÓPIA NÃO CONTROLADA
Initializes the system defaults and interface settings
(IP addresses also), SmartNetMonitor for Admin,
WebStatusMonitor settings, and the TELNET
settings.
Initializes the job login ID, SmartNetMonitor for
Admin, job history, and local storage file numbers.
Initializes the DCS (Delivery & Receive Control Server)
settings
Initializes the UCS (User Directory Control Server)
settings.
5-80
CÓPIA NÃO CONTROLADA
Rev. 5/2003
Comments
SM