Jam Conditions - Ricoh SP5 Series Service Manual

June 30, 1998

2.1.10 JAM CONDITIONS

A
[I]
B
C
1. The entrance sensor [I] has still not turned on when the feed-in motor has fed
the original twice the length [A] (between the original set position and the
entrance sensor).
2. The registration sensor [J] has still not turned on when the feed-in motor has
fed the original the length [B] (between the pre-feed position and the entrance
sensor).
3. The entrance sensor has still not turned off when the feed-in motor has fed the
original 1062 mm.
4. The registration sensor has still not turned off when the feed-in motor has fed
the original twice the length [C] (between the entrance sensor and the
registration sensor).
5. The exit sensor [K] has still not turned on when the transport and feed-out
motors have fed the original the distance [N].
N = F + 600 mm – (D + E)
F: Length between the original scale and the exit sensor
D+E : Total length of the originals on the exposure glass (e.g., for two A4
sideways pages. If there is only one page on the glass, E is zero)
6. The exit sensor has still not turned off when feed-out motor has fed the original
the length [G] (between the exit roller [L] and the exit sensor) + 65 mm after
reducing the feed-out speed.
7. The inverter sensor [M] is still not on when the feed-out motor has fed the
original twice the length [H] (between the exit sensor and the inverter sensor).
8. The exit sensor has still not turned off when the feed-out motor has fed the
original the length of the original after the inverter sensor [M] turned on.
9. The inverter sensor has still not turned off when the feed-out motor has fed the
original twice the length [H] (between the exit sensor and the inverter sensor)
after the exit sensor turned off.
D
[J]
2-13
DOCUMENT FEEDER
E
F
[K]
[M]
[L]
H
G
A806D502.WMF