Firmware History for B051/B052
1.4 FAX APPLICATION FIRMWARE HISTORY:
Initial Production Release
Corrects the following:
•
Supports Media Link Board function.
Corrects the following:
•
Minor bug correction for Japanese version.
Corrects the following:
•
Key input from the operation panel is sometimes disabled when changing over from
Copier to FAX mode under the following conditions.
-
Function Priority is set to Copier in User Tools.
-
Nothing is input for TTI No. 1 & 2.
-
Korea is registered as the country code in SP 1-101-016.
1.5 FCU FIRMWARE HISTORY:
Initial Production Release
Corrects the following:
•
Job numbers for standby for FAX transmission by LAN FAX (P/C FAX): System Switch
19 No.4 (SP1-101-026; page 57 in Service Manual)
System Switch 19 No.4 (SP1-101-026; page 57) added to FAX SP mode.
•
Job numbers for standby for FAX transmission by LAN FAX (P/C FAX) are limited as
follows:
0: 64 1: Depends on memory (400: standard, 800: with Fax Function Upgrade Unit)
•
Taiwan area
Taiwan Area parameters added.
Corrects the following:
•
Supports Media Link Board function.
•
Main power OFF/ON during original scanning
If the main power is turned OFF while the machine is scanning the original, the memory
capacity remains decreased when the power is turned back ON.
Corrects the following:
•
TX level of DTMF tone in Taiwan is slightly high.
CÓPIA NÃO CONTROLADA
SYMPTOM CORRECTED
SYMPTOM CORRECTED
CÓPIA NÃO CONTROLADA
FIRMWARE
VERSION
1.17
2.00
2.05
2.05.2
FIRMWARE
VERSION
02.01.00
03.01.00
04.00.01
05.00.00
Page 15 of 37