Development Unit - Ricoh B051 Service Manual

3.5 DEVELOPMENT UNIT


CAUTION
Do not touch the development unit sleeves or ID chip terminals.
1. Open the left cover [A] ( x 2)
2. ID chip connector [B]
3. Lift up the development unit [C],
and pull it out of the machine.
NOTE: Remove the units in the order
K, Y, C, M. For example,
before removing the M unit,
remove the K, Y, and C units
first.
4. Peel off the toner cartridge seal
[D].
5. Take out the toner cartridge from
the new development unit.
6. Shake the toner cartridge well, as shown.
NOTE: Hold the center of the
cartridge, at the other side
from the toner shutter, and
shake it about 10 times.
7. Reinstall the toner cartridge in the
development unit.
8. Shake the development unit well.
9. Tilt the unit about 90 degrees, and
shake it about 10 times.
10. Install the development unit to the
machine.
NOTE: A white line or band may
appear on one end of the
paper if a development is
incorrectly installed. To
correct this, pull out the
development unit partially
(about 30 mm) [D] and
slowly reinstall it.
SM
CÓPIA NÃO CONTROLADA
[B]
[C]
[D]
3-19
CÓPIA NÃO CONTROLADA
DEVELOPMENT UNIT
[A]
B051R103.WMF
B051I407.WMF
B051/B052