To Connect The Cte-600 Communication Transducer - Sony PCS-1 Operating Instructions Manual

To connect the CTE-600 Communication Transducer

Note
The CTE-600 Communication Transducer is currently not available.
Connecting cable
(supplied with the
CTE-600)
CTE-600
to an input/output
connector
To use the Communication Transducer connected to the Data Solution Box
• Set "CTE" in the Audio Setup menu to "DSB AUX IN" (page 51).
• Set the SYSTEM SELECT switch at the bottom of the Communication
Transducer to "PCS".
Note
You cannot use two or more Communication Transducers in a room and cannot use it
with other microphones together.
For detailed information on the Communication Transducer, refer to the
Operating Instructions that come with the Communication Transducer.
to an input/output connector
to LINE
to LINE
IN
OUT
to AUX IN
to AUX OUT
LINE OUT OUT AUX IN MIC 1 MIC 2 MIC 3
PCSA-DSB1S Data Solution Box (Rear)
Connection Example Using the Data Solution Box
Interface box
(supplied with the CTE-600)
to DC 6V
AC adaptor
(supplied with
the CTE-600)
Connecting cable
(not supplied)
MIC 4 MIC 5 TO PROCESSOR RGB OUT
to a wall
outlet
149